Pitney Bowes W983 User Manual
Page 20
17
SV61228 Rev. A
W983 Stacker/W863 Dryer Operating Guide
The top chart is used to determine the distance to set between the Stacker deck and
the DA Printer output roller. This is done by adjusting the height of the stand.
The bottom chart is used to determine the distance from the Stacker to the output roller.
This is done by moving the Stacker closer or farther from the DA Printer output roller.
In order to use the charts:
1
Measure the length and thickness of your material in inches.
2
Go to the length at the bottom of the chart and then up that line to the thickness
(the thickness must be approximated in the gray area which represents 3/8”
between the Min. thickness and Max. thickness).
3
Follow a straight line to the left side of the chart. That is the distance in inches for
that setting.
For example: if the material is 11 inches long and 1/8 inch thick, the reading on
the top chart would be approximately 2 inches and on the bottom chart approxi-
mately 1.75 inches.
STACKER HEIGHT AND DISTANCE - SUPER DRAFT & DRAFT MODE
Material Length (in inches)
5.0
5.5
6.0
6.5
7.0
7.5
8.0
8.5
9.0
9.5
10.0
10.5
11.0
11.5 12.0
12.5
13.0
0
0.5
1.0
1.5
2.0
2.5
3.0
3.5
4.0
4.5
5.0
5.5
V
e
rtical Distance (in inc
hes) -
W983 Con
ve
y
or Dec
k to D
A
Printer Output Roller
Max. thickness=3/8”
Min. thickness=0”
Material Length (in inches)
5.0
5.5
6.0
6.5
7.0
7.5
8.0
8.5
9.0
9.5
10.0
10.5
11.0
11.5 12.0
12.5
13.0
0
0.5
1.0
1.5
2.0
2.5
3.0
3.5
4.0
4.5
5.0
5.5
Horizontal Distance (in inc
hes) -
W983 Stac
ker to D
A
Printer Output Roller
Min. thickness=0”
Max. thickness=3/8”
Stacker_Dryer Op Guide Book.indb 17
Stacker_Dryer Op Guide Book.indb 17
3/30/2004 10:26:47 AM
3/30/2004 10:26:47 AM