Pitney Bowes W983 - Manual (Page 26)

23 SV61228 Rev. A
W983 Stacker/W863 Dryer Operating Guide
Adjust Dryer Height
You will have to adjust the height of the Dryer whenever the following
changes drastically from the previous job:
•
speed of the conveyor on the Stacker
• the size of the material being dried
• how much ink is used
The height handle is used to raise or lower the Dryer. It has six
positions.
Dryer Job Setup
You will be required to check and make the following adjustments
when you change from one job to another job.
Height is adjusted by squeezing the release lever under handle
top, lifting the Dryer unit to the new position, and then releasing the
handle in the new slot position.
Height Adjustment Handle
Release Lever
(under handle top) Six Positions
(see circle)
WARNING: The Dryer with Stacker combination
requires its own separate 15 amp branch circuit for
power. Do not plug other appliances (such as your
printer) into the same circuit as the Dryer/Stacker.
Stacker_Dryer Op Guide Book.indb 23 Stacker_Dryer Op Guide Book.indb 23 3/30/2004 10:26:48 AM 3/30/2004 10:26:48 AM