Planet Technology Network Device WAP-5100 - Manual (Page 27)

- 23 -
When you select SNMP Access Control, the system will display four blank fields for setting
(maximum of 4 SNMP devices can be set). Right-click on a blank in the list and click Edit Address.
The New/Edit Address dialog box will appear. Type in the IP address and set the password for the
SNMP device. There are two levels of access rights can be assigned:
•
Read: The user can read all information except the Access Control settings, but is not allowed to
alter anything.
•
Read/Write: The user can read and change all settings.
Please note do not set all SNMP devices in the table to Read only; otherwise the WAP-5100 is
impossible to be modified. The only solution is to reset the device back to factory defaults by using
Kick Start.
Trap Server
When the WAP-5100 is powered on, or an Ethernet port becomes active, an event log will be
generated indicating the time, the IP address of the reporting WAP-5100, and the event. You can
view and save the event logs from the station as a Trap Server. To assign a trap server, click Trap
Server tab.