Planet Technology Network Device WAP-5100 - Manual (Page 34)

- 30 -
stored file as a reference to compare with the latest test results and evaluate the difference between
them. In the following figure, the red line represents the latest test results and the green line
represents the previous test results.
Step 5: View test results as a three-dimensional graphic
The Antenna Alignment utility allows the user to view the test results in multiple ways:
•
2D (two-dimensional) or 3D (three-dimensional)
•
Zoom in for a magnified view or zoom out for a wider view
•
Rotation: rotate the view angle from side view
•
Elevation: rotate the view angle from top view
3.3.2.5 Restart
You can restart a selected WAP-5100 by opening the Host menu and select Restart, or click on the
icon . A warning message will pop up for confirmation. Click OK button to restart the device. The
restart process will take about 30 seconds. During this period, the WMS program will not be able to
query the WAP-5100 via the SNMP protocol.
3.3.2.5 Factory Reset
If you want to reset the WAP-5100 to its factory default settings, you can open the Host menu and
select Factory reset, or click on the icon . A warning message will pop up for confirmation.
Click Yes button to reset factory settings.
3.3.2.6 Upgrade Firmware
To upload the latest firmware to the WAP-5100, you can open the Host menu and select Upgrade
Firmware, or click on the icon . A dialog box will pop up. You may either enter the file name in