Panasonic AJ- E - Manual (Page 59)

Chapter 5 Preparation
5
59
Using the BP-90 type battery pack
1
Remove the battery holder.
Battery holder
2
Attach the battery case to the unit.
1 Connect the unit’s cable with the cable of the BP-90
type battery case.
2 Use a screwdriver to attach the BP-90 type battery
case to the unit.
The holes for tightening the screws can be seen when
the cover is opened and the rubber caps are raised.
Use a screwdriver to tighten the screws, and attach the
battery case to the unit. Ensure that the screws are
tightened up as far as they will go.
<Note>
≥
Do not pull the rubber caps with great force.
≥ Be careful not to catch up the cables when attaching the
battery case.
Connect
here.
BP-90 type
battery case
3
Connect the plug of the battery pack to the connector
inside the battery case, and insert the battery pack into
the case.
<Note>
Ensure that the power is turned off before connecting or
disconnecting the plugs.
Label
surface
4
Set the battery type.
Select the battery type using the BATTERY SELECT
menu item. This item is selected from the
<BATTERY/TAPE> screen on the VTR FUNCTION page.
For details, refer to “7-8-3 BATTERY SETTING1.”