Panasonic VB-43320 - Manual (Page 6)

Panasonic@
June
Release
CPC-EX, Version 1 .O (Preliminary;
FF-Key Programming
Because Networking adds the capability of 4-digit extension numbering, you can now program
up to 8 digits (not 6) into an
Speed Dial Enhancements
CPC-EX supports up to 500 System Speed Dial (SSD) numbers. CPC-EX also allows SSD codes to
be chained, or “linked”, to another SSD number, and either PSD or SSD codes to be chained to a
PSD number.
Additional Serial Port
The CPC-EX card contains an on-board serial port (Serial Port 2) which can be used for Bus
Monitor/Maintenance. This allows remote maintenance to be accomplished without disconnecting
SMDR cabling.
Networking Capability
Up to 4 DBS’s can now be connected together via interface to form a DBS phone network. The
DBS’s can be located in the same building, in separate buildings in a campus-type environment, or at
remote locations in separate states. Networked DBS’s use 4-digit extensions, with the first digit of
the extension number identifying the DBS site.
Each site requires its own DBS cabinet with a CPC-EX card and a card. ‘New programming
addresses are included in CPC-EX software for setting up the Network. (see the Networking
Reference Manual for complete instructions)
Modification to Toll Restriction Service
The program address for TRS Operator Access (FF7 has been modified to allow an
extension to dial phone numbers, even if “O-only” dialing is denied.
Maximum Time Priority Route Tables
CPC-EX allows a maximum of 8 Time Priority Route Tables (not 15) to be used during LCR
programming. Since few systems use more than 3 Time Priority Route Tables, this change will
allow the saved memory space to be used for future enhancements.
SMDR Modifications
SMDR reports contain several new call types and other parameters due to CPC-EX support of
Networking and ISDN calls.
Introduction
l
Page 5
Technical Manuals Online! - http://www.tech-man.com