Planet Technology ISDN Internet Telephony PBX System IPX-1800N - Manual (Page 24)

PLANET IP PBX user’s manual
settings.
Restart IP PBX
Configuration
Click RESTART, and the IP PBX Service will restart completely.
Currently active calls will be disconnected immediately. This
function is rarely required unless the network setting has been
changed, or the service operates abnormally without
problematic configuration could be identified.
Revert IP PBX
Configuration
Click REVERT, and IP PBX will erase current IP PBX settings
and revert configuration back to the factory default. Note the
reversion affects IP PBX service only, but not other system
services such as DHCP, TFTP, and NTP. The backup IP PBX
configuration files under TFTP remain intact after reversion, so
that one can restore to a specific time if a backup file had been
generated then.
To revert the whole system back to the factory default as much as possible, hold the hardware Reset
button for 10 seconds. Since this will wipe out almost everything generated by the user, all system
interfaces and services must be configured from scratch again if no appropriate backup configuration
could be restored. Note that such reversion will not erase backup configurations and existing
voicemails. Backup configuration files could be deleted in the TFTP Service page and voicemails
could be deleted in the Maintenance page.
3.6.7 Advance
Select Service -> IP PBX Service, and then click the Advance tab to configure IP PBX parameters.
After the configuration, go to Service -> IP PBX Service, and click RESTART to activate changes.