Panasonic SC-BTX70 - Manual (Page 42)

42
RQT9479
Wireless connections (optional)
By connecting 1 or 2 units of the optional Panasonic wireless system SH-FX70 with 2 or 4 additional speakers, it is possible to change this unit
into a 4.1 ch or 6.1 ch home theater system.
This system's surround sound effect settings will change (
> 15) and it is possible to listen to the true, original surround audio signals of the
playback contents. (However, the center channel included in the audio source will be output from the front L R speakers.)
∫ Wireless setup diagram
e.g., 4.1ch e.g., 6.1ch
LS: Surround (left), RS: Surround (right)
≥Place behind the seating position, about 1 m (3 ft) higher than ear
level.
LS: Surround (left), RS: Surround (right)
≥Place on the side of the seating position.
LB: Surround back (left), RB: Surround back (right)
≥Place behind the seating position, about 1 m (3 ft) higher than ear level.
∫ Digital transmitter
1 Push $ to open the digital transmitter door.
2 Insert fully until you hear a click.
∫ Wireless system
∫ AC power supply cord
Connecting the surround, surround back speakers and the optional wireless system
(SH-FX70)
LS RS
LS
LB RB
RS
Main unit
(with the digital
transmitter)
Seating position
Surround speaker cables
Main unit
(with the digital
transmitter)
Seating position
Surround speaker cables
SH-FX70: 1 unit SH-FX70: 2 units
Preparation Preparation
Additional speakers:
1 set Additional speakers:
2 sets
≥Turn off all equipment before connection and read the appropriate operating instructions.
≥Connect the AC power supply cord after all other connections are complete.
≥Do not use the wireless system and digital transmitter in a metal cabinet or bookshelf.
≥Place the wireless system within approximately 15 m (47 ft) from the home theater unit. NOTE
Connections
Do not insert or remove while the main unit is on.
SH-TR70 digital transmitter
Push!
SPEAKERS ENCEINTES LS / RB LB / RS
SURR I/D SET
AC IN
SURROUND (3 – 6 ) AMBIOPHONIQUES L SIDE R SIDE
SURR
L
SIDE
R
SIDE
SURR
L
SIDE
R
SIDE
Surround
selector
Connecting the speakers to the wireless system
Connect to terminals of the same color.
Insert fully.
Speaker cable
For 4.1ch connection
SURROUND (LS): Blue
SURROUND (RS): Grey
For 6.1ch connection
SURROUND (LS): Blue
SURROUND BACK (LB): Grey
SURROUND (RS): Grey
SURROUND BACK (RB): Blue
Selector setting for the
left and right speakers
Selector setting for the
left speakers
Selector setting for the
right speakers
Impedance: 3 ≠ to 6 ≠
Speaker input power: 100 W (Min)
AC power supply cord
(included with SH-FX70)
To household AC outlet
(AC 120 V, 60 Hz)
Optional speaker
settings
BTX70PP_eng.book 42 ページ ２００９年６月２４日 水曜日 午後３時４２分