Panasonic AW-HE100N - Manual (Page 18)

18
Selecting the units
Up to four units can be operated using one accessory wireless remote control.
Up to five units and devices can be operated using one controller.
Select the unit (or units) to be operated from the wireless remote control or controller.
Even when using only one unit, it must still be selected.
When performing the operations using the
accessory wireless remote control
Press the [CAM1], [CAM2], [CAM3] or [CAM4]
button.
The unit’s status display lamp blinks green when a signal
matched by the remote control ID has been received, and
it blinks orange when a signal that is not matched by the
remote control ID has been received.
When performing the operations
using the controller
When the AW-RP655 is connected:
Press the [1], [2], [3], [4] or [5] button of
[CONTROL/PREVIEW MONITOR OUT SEL].
When the AW-RP555 is connected:
Press the [1], [2], [3], [4] or [5] button of
[CONTROL].
When the AW-RP400/AW-CB400 is connected:
Press the [1], [2], [3], [4] or [5] button of
[CONTROL SELECT].
 Operations can be performed from both the
AW-RP400 and AW-CB400, but depending on the
settings, it may be possible to perform the operations
using only one of the controllers.
For further details, refer to the Operating Instructions of the
controller.