Panasonic AW-HE100N - Manual (Page 56)

56
Troubleshooting
 Operation
Symptom Cause and remedial action Reference pages
No power
 Has the power plug been connected securely to the AC power
outlet?
—
 Has the power plug been connected properly? —
 If the unit is connected to the controller, has it been connected
properly?
 Refer to the Operating Instructions of the controller.
Installation
Instructions
P.9 to 31
 When the unit is being operated by the wireless remote control
 Also refer to the “Cannot operate using the wireless remote control”
item.
—
Cannot operate
(common to wireless
remote control,
controller)
 Is the power on?
 If the unit’s status display lamp is off or if it has lighted up orange,
it means that the unit’s power is not being supplied.
P.16
 Has the correct unit to be operated been selected? P.18
 One of the safe mode functions may have been activated. P.55
 Have the limiter functions been set? P.53 to 54
 Was the setting for “Controller” (accept control from control device
selection) on the menu item changed previously?
 Change the setting by following the steps on the reference page.
P.43
Cannot operate
using the wireless
remote control
 Have the remote control’s batteries run down or have the batteries
been installed with their polarities reversed?
 If the status display lamp does not blink even when the wireless remote
control is operated near the wireless remote control signal light-sensing
area, it means that the batteries have run down. Replace the batteries.
—
 Is there a fluorescent light or plasma monitor near the unit and, if so,
is the wireless remote control signal light-sensing area exposed to
its light? P.14
Cannot operate
using the controller
 Is the unit connected to the controller properly?
 Refer to the Operating Instructions of the controller.
Installation
Instructions
P.9 to 31
 Has the controller selector switch been set to the correct setting?
 Check the switch setting.
 Refer to the Operating Instructions of the controller.
Installation
Instructions
P.9 to 31
 It may be necessary to upgrade the version of the controller so that
the controller will support the unit.
 Consult with your dealer.
—
 If the unit is being used in combination with the AW-RP400 and
AW-CB400, a setting to prohibit the operation of one of these devices
may have been established.
 Refer to the Operating Instructions of the controller.
—
The unit turns in the
opposite direction to
the one operated
 Has the stand-alone (Desktop) installation setting been selected
correctly?
Installation
Instructions
P.1
 When the picture has been inverted by the automatic picture flipping
function, the unit may appear to turn in the opposite direction to the
one operated. P.43
 The reversal setting may have been established at the controller
if the unit is connected to the controller.
 Refer to the Operating Instructions of the controller.
—