Panasonic AW-HE100N - Manual (Page 30)

30
 Calling the settings of the preset memories
1
Set to the preset memory mode.
Press the [TR/PSET] button to turn off its lamp.
2
Press the button among the [1] to [50]
buttons of [TRACING/PRESET MEMORY]
in which the desired setting was
registered.
 Erasing preset memory settings
1
Set to the preset memory mode.
Press the [TR/PSET] button to turn off its lamp.
2
Set the memory recording mode.
Press the [M.LOCK] button to turn off its lamp.
3
Hold down the [RESET] button.
The buttons among the [1] to [50] buttons of
[TRACING/PRESET MEMORY] whose settings can be
erased now start blinking in sequence.
 The settings for the buttons whose lamps are off
cannot be erased (since they contain tracing memory
settings).
4
With the [RESET] button still held down,
press the button of the preset memory
number whose setting is to be erased.
When the AW-RP555 is connected:
Up to 10 settings can be registered and called.
The [1] to [10] buttons of [PRESET] correspond to the unit’s
preset memories No.1 to No.10.
 Registering the settings in the preset memories
1
Display the picture to be shot on the
monitor.
Operate the [PAN/TILT] lever and [ZOOM] lever to
determine the camera angle.
Adjust the focus and iris if they need to be adjusted.
2
Hold down the [MEMORY] button.
The buttons among the [1] to [10] buttons of [PRESET]
in which settings can be registered now start blinking in
sequence.
3
With the [MEMORY] button still held
down, press the button of the preset
memory number in which the setting is to
be registered.
 Calling the settings of the preset memories
1
Press the button among the [1] to [10]
buttons of [PRESET] in which the desired
setting was registered.
When the AW-RP400 is connected:
Up to 50 settings can be registered and called.
The [1] to [50] buttons of [PRESET MEMORY] correspond to
the unit’s preset memories No.1 to No.50.
 Registering the settings in the preset memories
1
Display the picture to be shot on the
monitor.
Operate the [PAN/TILT] lever and [ZOOM] lever to
determine the camera angle.
Adjust the focus and iris if they need to be adjusted.
2
Hold down the [MEMORY] button.
3
With the [MEMORY] button still held
down, press the button of the preset
memory number in which the setting is to
be registered.
 Calling the settings of the preset memories
1
Press the button among the [1] to [50]
buttons of [PRESET MEMORY] in which
the desired setting was registered.
Preset memories