Primera Technology Primera Bravo Automated Opitcal Disc Duplication & Printing System II - Manual (Page 13)

Hardware and Software Set-Up 9
c. Double-click on the Disc Publisher Installer.mpkg file
icon. Follow the on-screen instructions.
d. The volume containing the operating system should be
selected for installation. Click the Continue button. All
components will be installed to their proper locations.
e. Once the installation has completed, click Quit.
You have successfully installed all the necessary software!
Section C below will describe how to connect the Bravo to
your Mac.
C. HARDWARE SETUP
To connect your new disc publisher, please do the following:
Be sure you have removed the packing tape and cardboard insert prior
to applying power.
Step 1: Applying Power
• Locate the power adapter supplied with your Publisher.
• Place one end of the adapter cord into the power port
on the rear panel of the Publisher.
• Unit will initialize for approximately 30 seconds or so.
Step 2: Loading Media (Discs)
NOTE: Your Publisher can print directly onto virtually any brand of
printable-surface CD/DVD media. However, different brands of discs
have different printable coatings. Because of this, you may need to
adjust the printer driver settings to accommodate your specific brand
of CD/DVD media. Refer to Section 3A or 4E for further printer
driver information.
Due to the wide variety of printable-surface CD/DVD media, you
may find that certain brands of discs provide higher print quality
than others. For maximum print quality, use CD/DVD media
authorized by Primera.
510873PM.qxd 4/3/2006 4:56 PM Page 9
TOC INDEX