PYLE Audio FWM352 - Manual (Page 12)

12
English
Basic Functions
IMPORTANT!
Before you operate the system, complete
the preparation procedures.
Plug and Play (for tuner installlation)
Plug and Play allows you to store all available
radio stations automatically.
First time setup/power up
1
When you turn on the main supply, " AUTO
INSTALL - PRESS PLAY" is displayed.
2
Press ÉÅ to start installation.
➜ " PLUG AND PLAY" .... "INSTALL" is
displayed, followed by " TUNER" and "AUTO".
➜
PROG starts flashing.
➜ All available radio stations with sufficient signal
strength will be stored automatically, starting
from FM and followed by MW band.
➜ When all the available radio stations are
stored or the memory for 40 presets are used,
the first preset radio station will be played.
To reinstall Plug and Play
1
In standby or demonstration mode, press and
hold
ÉÅ on the system until "AUTO INSTALL
- PRESS PLAY" is displayed.
y
CD1/2/3 MUTE
REPEAT PROGRAM SHUFFLE
DSC DBB
DISPLAY DIM SLEEP
TITLE
ALBUM
AUX TUNER
VOL
TIMER
ON/OFF
2
Press ÉÅ again to start installation.
➜
All previously stored radio stations will be
replaced.
To exit without storing the Plug and Play
● Press Çon the system.
➜
If you do not complete the Plug and Play
installation, the function will be restar ted when
you next turn on the main supply again.
Notes:
– When the power is turned on, the disc tray may
open and close to initialise the system.
– If no stereo frequency is detected during Plug
and Play, "
CHECK ANTENNA" will be displayed.
– During Plug and Play, if no button is pressed
within 15 seconds, the system will exit Plug and
Play mode.
pg001-027_M352_22_Eng 2005.12.23, 15:53 12