PYLE Audio FWM352 - Manual (Page 24)

24
English
Clock/Timer
To check the remaining length of time
after sleep timer is activated
● Press SLEEP (TIMER ON/OFF) once.
To change the preset sleep timer
● Press SLEEP (TIMER ON/OFF) again while
the remaining sleep timer is shown.
➜
The display will show the next sleep timer
options.
To deactivate the sleep timer
● Press SLEEP (TIMER ON/OFF) repeatedly
until "
OFF" is displayed, or press STANDBY-
ON/ ECO POWER (B).
Note:
–
will start flashing when the remaining
length of time after activation of the sleep timer is
less than 1 minute.
4
Press í or ë repeatedly to set the minute for
the timer to start.
5
Press CLOCK•TIMER to store the start time.
● At the preset time, the selected source will play.
To exit without storing the setting
●
Press STOP Ç on the system.
Notes:
– When the preset time is reached and the
selected disc tray is empty, the next available disc
will be selected. If all the disc trays are not
available, Tuner will be selected automatically.
– During timer setting, if no button is pressed
within 25 seconds, the system will exit timer setting
mode automatically.
To deactivate the TIMER
● Press and hold SLEEP (TIMER ON/OFF) on
the remote control.
➜ The display will show " OFF" and will
disappear from the display.
To activate the TIMER
●
Press and hold SLEEP (TIMER ON/OFF) on
the remote control.
➜ The last set timer information will be shown
for a few seconds and will appear on the
display.
Sleep timer setting
The sleep timer enables the system to switch to
standby mode automatically at a preset time.
1
Press SLEEP (TIMER ON/OFF) on the
remote control repeatedly to select a preset
time.
➜
The selections are as follows (time in
minutes):
15 ™ 30 ™ 45 ™ 60 ™ OFF ™ 15 …
2
When you reach the desired length of time, stop
pressing the
SLEEP (TIMER ON/OFF)
button.
➜
is shown, except for "
OFF" mode.
➜
The sleep timer is now set.
pg001-027_M352_22_Eng 2005.12.23, 15:53 24