Peerless Industries A100IWBMOUNT - Manual (Page 12)

ISSUED: 04-08-08 SHEET #: 055-9094-2 06-06-08
Visit the Peerless Web Site at www.peerlessmounts.com For customer care call 1-800-865-2112 or 708-865-8870.
12 of 16
FRONT VIEW
I
fig. 10.3
C
J
N
P
Arrow on projector mount assembly (J) indicates front of mount. The arrow of projector mount assembly (J) should
face towards the round tube on projector arm (C).
Fasten projector mount assembly (J) to projector arm (C) using two 1/4-20 x 1.0" hex head screws (N), four 0.25" ID
nylon washers (P) and slide plate (I) as shown in fig. 10.2 and 10.3. Do not tighten 1/4-20 x 1.0" hex head
screws (N) fully to allow for adjustment. Insert rectangle plug (S) into projector arm (C) as shown in fig. 10.2.
Position projector mount assembly (J) so that hole corresponding to your size screen in projector arm (C) is in the
center of projector mount assembly (J) as shown in fig. 10.1. Securely tighten both 1/4-20 x 1.0" hex head screws
(N). NOTE: This can be adjusted during final projector alignment if needed.
10
fig. 10.2 P
J
N
I
C
S
Bottom View
fig. 10.1
C
77" SCREEN
63" SCREEN
ARROW INDICATES
FRONT OF MOUNT
ROUND TUBE