Panasonic KX-TA624 - Manual (Page 31)

Station Programming (Personal Programming) 2-3
2.1 Station Programming Instructions
To confirm the assigned data
—Be sure that you are in the Station Programming mode. Set the MEMORY switch to
“PROGRAM”.
PT
Press HOLD. Enter the program access number.
program access number
HOLD
— To exit the Station Programming mode, set the MEMORY switch to “SET”.
— If you wish to change the data, follow the programming procedure explained in this
section.
* A program access number is required to program/confirm the data by Station Programming.
• Enter the program access number* as follows.
- 1: Preferred Line Assignment — Outgoing
- 2: Preferred Line Assignment — Incoming
- 3: Outside (CO) Line Ringing Selection
- 4: Intercom Alert Assignment
- 5: Call Waiting Tone Type Assignment
- 6: Self-Extension Number Confirmation (KX-T7030 and KX-T7130 only)
- 7: Extension Password Set (Manager only)
- 0: Date and Time Setting (Operator/Manager only)
• The display shows the programmed data.
<PT Display Example>
When you press “5”, the display shows:
— The Call Waiting tone is currently programmed to Tone 1. C.W.Tone-1
• The display shows the initial programming mode.