Planet Technology VRT-401G - Manual (Page 32)

Parameters Description
2.2.1 Dynamic IP address Your ISP will automatically give you an IP address
2.2.2 Static IP address
Your ISP has given you an IP address already
2.2.3 PPPoE
Your ISP requires PPPoE connection.
2.2.4 PPTP
Your ISP requires you to use a Point-to-Point Tunneling
Protocol (PPTP) connection.
2.2.5
L2TP Your ISP requires L2TP connection.
2.2.6 Telstra Big Pond
Your ISP requires Telstra Big Pond connection.
2.2.7
DNS You can specify a DNS server that you wish to use
2.2.8 DDNS
You can specify a DDNS server that you wish to use and
configure the user name and password provided by you
DDNS service provider.
Once you have made a selection, click <More Configuration> at the bottom of the screen, and
proceed to the manual’s relevant sub-section
2.2.1 Dynamic IP
Choose the Dynamic IP selection if your ISP will automatically give you an IP address. Some
ISP’s may also require you to fill in additional information such as Host Name, Domain Name and
MAC address (see chapter 1 “Cable Modem” for more detail)
2.2.2 Static IP Address
Select Static IP address if your ISP has given you a specific IP address for you to use. Your ISP
should provide all the information required in this section. (See chapter 1 “Fixed IP” for more
detail)
2.2.3 PPPoE (PPP over Ethernet)
Select PPPoE if your ISP requires the PPPoE protocol to connect you to the Internet. Your ISP
should provide all the information required in this section. (See chapter 1 “PPPoE” for more detail)
2.2.4 PPTP
Select PPTP if your ISP requires the PPTP protocol to connect you to the Internet. Your ISP
should provide all the information required in this section. (See chapter 1 “PPTP” for more detail)
32