Planet Technology VRT-401G - Manual (Page 48)

Remove MAC address from the list If you want to remove some MAC address from
the "Current Access Control List ", select the
MAC addresses you want to remove in the list
and then click "Delete Selected". If you want
remove all MAC addresses from the table, just
click "Delete All" button. Click "Reset" will clear
your current selections.
Click <Apply> at the bottom of the screen to save the above configurations. You can now
configure other advance sections or start using the router (with the advance settings in place)
2.5 QoS
The QoS can let you classify Internet application traffic by source/destination IP address and port
number. You can assign priority for each type of application and reserve bandwidth for it. The
packets of applications with higher priority will always go first. Lower priority applications will get
bandwidth after higher priority applications get enough bandwidth. This can let you have a better
experience in using critical real time services like Internet phone, video conference …etc. All the
applications not specified by you are classified as rule name “Others”. The rule with smaller
priority number has higher priority; the rule with larger priority number has lower priority. You can
adjust the priority of the rules by moving them up or down.
Note: If the total assigned bandwidth of higher priority applications is larger than the
maximum bandwidth provided by the WAN port, the other applications will not get any
bandwidth.
Parameters Description
Enable/Disable QoS
You can check “Enable QoS” to enable QoS
function for the WAN port. You also can uncheck
“Enable QoS” to disable QoS function for the
WAN port.
48