Panasonic MC-UG787 - Manual (Page 38)

- 38 -
Replacing Belt
Agitator
Agitateur
Agitador
Belt
Courroie
Correa
Motor Shaft
Arbre du moteur
Eje del motor
Motor Shaft
Arbre du moteur
Eje del motor
Belt Groove
Polea para correa
Rainure de la courroie
End Cap
Bouchon
Tapa del
extremo
Slot
Fente
Ranura
Nozzle
Tête d'aspiration
Boquilla
Agitator
Agitateur
Agitador
➢ ➢ Replace belt whenever a burning
rubber smell caused by excessive
slippage occurs.
➢ ➢ Remove lower plate. See “Removing
and Installing Lower Plate”
➢ ➢ Remove agitator by carefully lifting
out.
➢ ➢ Remove worn or broken belt.
➢ ➢ Clean agitator and the end caps.
➢ ➢ Loop new belt around motor shaft
and agitator belt groove; see
illustration for correct belt routing.
➢ ➢ Reinstall agitator back into nozzle
housing grooves.
➢ ➢ After reinstalling the agitator, turn it
by hand to make sure that belt is not
twisted or pinched and that all
rotating parts turn freely.
➢ ➢ Reinstall lower plate. Ensure tabs are
locked into slots.