Pioneer DVD-V5000 - Manual (Page 12)

12
02 Connecting up
Connecting using the
S-video output
If your TV (or other equipment) has an S-video
input, you can use this instead of the standard
(composite) output for a better quality picture.
• Use an S-video cable (not supplied) to
connect the S-VIDEO OUT to an S-video
input on your TV (or monitor or AV
receiver).
Line up the small triangle above the jack
with the same mark on the plug before
plugging in.
Connecting using the
component video out-
put
You can use the component video output instead
of the standard video out jack to connect this
player to your TV (or other equipment). This
should give you the best quality picture from the
three types of video output available.
• Use a component video cable (not
supplied) to connect the COMPONENT
VIDEO OUT jacks to a component video
input on your TV, monitor or AV receiver.
• Only NTSC video is output when set to
progressive scan.
• To set up the player for use with a progres-
sive scan TV, see About progressive scan
video on page 15.
TV
S-VIDEO
IN
TV
COMPONENT
VIDEO IN
When COMPONENT VIDEO OUT is set to
Progressive, there is no video output from
the
S (S-video) jack. If you want to display
video on the monitor, make sure that it is set
to
Interlace. Press PROGRSSIVE on the
front panel to switch the player back to
Interlace.