Power on start, 42 09 advanced setup menu – Pioneer DVD-V5000 User Manual
Page 42
42
09
Advanced Setup Menu
• SERIAL PORT
Set the RS-232C interface to use with a 15-pin
connector or 9-pin connector. Only a single
type of connector may be used at a time.
Use
/ (cursor left/right) buttons to
alternate between
15 Pin and 9 pin (Default
setting is
15 Pin).
15 Pin:
When connecting to a PC using
a Pioneer or other brand 15-pin
to 9-pin cable.
9 Pin:
When connecting to a PC using
a commercial 9-pin cross-cable.
• BAUD RATE
Sets the Baud rate for the RS-232C
interface.
Use
/ (cursor left/right) buttons to
alternate between
19200 bps and 9600 bps
(Default setting is
19200 bps).
• EXTEND TERMINAL
Use the Extend Terminal to select a switch-
key setting.
Use
/ (cursor left/right) buttons to
alternate between
Standard and User
(Default setting is
Standard).
Standard: The unit responds according to
established standard setting
(see pages 68 – 70).
User: The user selects how the
external option key responds.
Press
ENTER to activate this
option (see page 46).
• SYNC OUT (DURING SQ)
Use SYNC OUT to determine if a video signal
is sent when the player is not playing video.
Use
/ (cursor left/right) buttons to
alternate between
ON and OFF (Default
setting is
OFF).
OFF:
Video is output constantly; the
sync signal is ON.
ON:
Video is not output except
during playback and when
displaying menu screens (sync
signal is off).
Power On Start
Sets playback mode when power is turned on.
1
Press and hold HOME MENU for one
second.
The screen displays the ADV. SETUP menu.
2
Use the (cursor down) button to
select POWER ON START.
3
Use the
/ (cursor left/right) buttons
to select a mode other than OFF, then
press ENTER.
When OFF is selected, Power On Start
function is disabled.
4
Use the
/ (cursor up/down) buttons
to select 1, 2, or 3, then press ENTER.