Planet Technology Network Device WAP5 - Manual (Page 23)

- 19 -
When you select SNMP Access Control, the system will display four blank fields for setting
(maximum of 4 SNMP devices can be set). Right-click on a blank in the list and click Edit Address.
The New/Edit Address dialog box will appear. Type in the IP address and set the password for the
SNMP device. There are two levels of access rights can be assigned:
•
Read: The user can read all information except the Access Control settings, but is not allowed to
alter anything.
•
Read/Write: The user can read and change all settings.
Please note do not set all SNMP devices in the table to Read only; otherwise the WAP-5000 is
impossible to be modified. The only solution is to reset the device back to factory defaults by using
Kick Start.
MAC Access Control
You can restrict the wireless connection of WAP-5000 by using MAC Access Control. There are up
to 1000 stations can be granted or denied access. There are three Access Options can be
selected:
•
Disabled: Disable the MAC Access Control. This is the default setting.
•
Accepted List: Wireless stations with MAC addresses on the list are allowed to access
WAP-5000.
•
Denied List: Wireless stations with MAC addresses on the list are prohibited to access WAP-5000.