Panasonic DMC-TZ1 - Manual (Page 14)

Preparation
14
VQT0V40
Inserting/Removing
the Battery
• Check that the camera is turned off and
that the lens is retracted.
1 Slide the release lever in the
direction of arrow and open the
card/battery door.
• Always use genuine Panasonic
batteries (CGA-S007A).
2 Insert:
Insert the charged battery until it
clicks.
Remove:
Slide the lock
A to remove the
battery.
3 1 Close the card/battery door.
2 Slide the release lever in the
direction of the arrow.
• Remove the battery after use. Store the
removed battery in the battery carrying
case (supplied).
• When a fully charged battery has been
inserted for more than 24 hours, the clock
setting is stored (in the camera) for at
least 3 months even if the battery is
removed. (If you insert a battery that is not
sufficiently charged, the length of time that
the clock setting is stored may become
less.) However, the clock setting is
canceled after this length of time. In this
case, set the clock again. (P18)
• Do not remove the card or the battery
while the card is being accessed. The
data may be damaged. (P16)
• Remove the batteries after the LCD
monitor and the status indicator
(green) turn off. Otherwise, the settings
on the camera may not be stored
properly.
• Do not remove the battery with the
camera turned on as the settings on
the camera may not be stored properly.
• The supplied battery is designed only
for the camera. Do not use it with any
other equipment.
OPEN LOCK
OPEN LOCK
VQT0V40ENG.book 14 ページ ２００６年２月２７日 月曜日 午後１時１９分