0 configuration, 1 configuring the hardware dip switches, Configuration – Patton electronic 12168 User Manual
Page 15: Configuring the hardware dip switches
Advertising
15
4.0 CONFIGURATION
The Model 1068 has four DIP switches for configuring the unit for a wide
variety of applications. This section describes switch locations and
explains the different configurations.
4.1 CONFIGURING THE HARDWARE DIP SWITCHES
Using a small flat-tip screwdriver, remove the protective cover located on
the underside of the Model 1068 (see Figure 10).
Figure 10.
Removing protective cover
Figure 11 and Figure 12 on page 16 show the orientation of the DIP
switches in the On and Off positions.
VLINK Modem
Po
we
r
Link
QOL
Link
Activity
VLINK
Ether
net
Advertising