Patton electronic 12168 - Manual (Page 9)

9
3.0 INSTALLATION
Because the Model 1068 requires no configuration, it can be installed
quickly. If you are installing a standalone unit, refer to section 3.1 “Standal-
one unit installation”. Otherwise, refer to section 3.2 “Rack card installation”.
Note If asymmetric transmission or line rates other than 12.5 Mbps
are required, refer to section 4.0, “Configuration” on page 15.
3.1 STANDALONE UNIT INSTALLATION
Do the following:
1. Connect the line interface between the units (refer to section 3.3,
“Connecting the Twisted-Pair Line Interface” on page 11)
Note See Figure 2 for the standalone unit’s rear panel arrangements.
2. Connect the Ethernet interface (refer to section 3.4, “Connecting the
10/100Base-T Ethernet Interface” on page 12).
3. Connect the power plug (refer to section 3.6, “Connecting Power” on
page 14).
Figure 2. Model 1068 standalone rear panel
Ether
net
VLINK
Po we
r
Made in the USA
POTS/ISDN
twisted-pair
terminal block
interface
Power
jack
Ether
net
VLINK
Po we r
Made in the USA
Ethernet
port
VDSL twisted-pair
terminal block
interface
VDSL twisted-pair
RJ-45 interface
PO
TS/ISDN
1068DV
1068D