Switch settings – Pelco Universal Keyboard KBD300A User Manual
Page 26
[ 26 ]
Pelco Manual C527M-L (3/04)
SWITCH SETTINGS
To set the switches on the keyboard (refer to Figure 11):
ᕡ
Remove the two screws and the DIP switch cover plate from the rear of the keyboard.
ᕢ
Set the switches:
• Address (Switches 1-4)
Position the switches according to Table B. Each keyboard in the system must have a different address,
including the local keyboard. To make programming easier, address keyboards in ascending order.
NOTE:
CM6700 accepts only eight addresses.
Table B. Keyboard Addresses
Keyboard
Switch Settings
1
2
3
4
1
OFF
OFF
OFF
OFF
2
ON
OFF
OFF
OFF
3
OFF
ON
OFF
OFF
4
ON
ON
OFF
OFF
5
OFF
OFF
ON
OFF
6
ON
OFF
ON
OFF
7
OFF
ON
ON
OFF
8
ON
ON
ON
OFF
9
OFF
OFF
OFF
ON
10
ON
OFF
OFF
ON
11
OFF
ON
OFF
ON
12
ON
ON
OFF
ON
13
OFF
OFF
ON
ON
14
ON
OFF
ON
ON
15
OFF
ON
ON
ON
16
ON
ON
ON
ON
• Mode (Switches 5, 7, 8)
Position the switches according to Table C. Switch 6 enables/disables turbo pan. It can be switched
while the keyboard is on.
Table C. Keyboard Modes
CM6700/CM6800** Direct P** CM6700 ASCII*** CM6800 ASCII*** Direct D*** CM9760-MDA*
Switch 5
OFF
ON
OFF
OFF
ON
ON
Switch 6
ON or OFF
ON or OFF
ON or OFF
ON or OFF
ON or OFF
ON or OFF
Switch 7
OFF
OFF
ON
ON
ON
OFF
Switch 8
OFF
OFF
OFF
ON
OFF
ON
***
*Firmware version 4.00 and higher.
**
**Firmware version 4.20 and higher automatically recognizes CM6700/CM6800 and Direct P Mode.
*
***Firmware version 5.00 and higher.