Pelco Universal Keyboard KBD300A - Manual (Page 33)

Pelco Manual C527M-L (3/04) [ 33 ]
Zones
The Zone function is available on Esprit and Spectra positioning systems when operated through a
CM6700 or CM6800 switch.* This function puts a label on the screen to identify the viewing area. Zones
can also be blanked to prevent viewing while the camera is positioned in the zone.
Up to eight pan (horizontal) zones can be defined (zones are not affected by tilt or zoom). Higher num-
bered zones take precedence so that if zones overlap, the one with the higher number is in effect. Zone
programming is outlined in Table H.
Table H. Zone Programming Procedure
Step Procedure
1. Set left zone limit. a. Use the joystick to position the camera at the start (left limit) of the
zone.
2. Access zone a. Press 8, followed by the zone number N (N = 1 through 8), and then
programming. the AUX ON key to display the zone menu.
3. Define a label. a. Use F1 and F2 to find the characters for each position in the label
HINT: To ease (26 upper case letters, 26 lower case letters and 10 numbers).
future title editing, b. Pan left/right to move between character positions. Continue
start each title with selecting characters until the title is completed (up to 20 charac-
ters).
Z(N), where c. Move down to the SET field and press ACK or tap the joystick to the
N = zone number. right and release.
4. Set right zone limit. a. Position camera at the right limit of the zone.
b. Press 8, followed by the zone number, and then the AUX OFF key.
c. To view zone titles go to step 6.
5. Clear zones. a. Press 8, followed by the zone number, and then the AUX ON key.
b. Move down to the SET field and Press ACK.
NOTE: DO NOT pan right.
c. Press 8, followed by the zone number, and then the AUX OFF key.
6. Turn on zone labeling. a. Press 9, 1, the AUX ON key.
7. Turn off zone labeling. a. Press 9, 2, the AUX ON key.
8. Blank zones. a. Press 9, 5 and hold Preset for about 2 seconds to display the Edit
Preset 95 menu.
b. Move down to the SET field and press ACK to display the Camera
menu.
c. Move down to the <Alarms, Zone Blank> field and press Iris Open to
display the Alarms, Zone Blank menu.
d. Move down to the <Zone Blank> field and press Iris Open to display
the Zone Blank menu.
e. Move down to the zone number you wish to blank and press Iris
Open to move the cursor arrow to the zone blanking status value.
f. Pan up to turn blanking on, pan down to turn blanking off.
g. Press Iris Open to accept new status; press Iris Close to cancel.
h. Repeat steps 8e through 8g for each zone you wish to change, and
then go to step 8i.
i. Move down to Exit and press Iris Open repeatedly to move up
through the menus and return to the normal display.
*Zones cannot be used in Direct P or Direct D mode.