Pioneer PDV-LC20 - Manual (Page 15)

15
En
02 Getting Started
English
6 To pause playback, press
8.
• On a DVD, DVD-RW or Video CD, the
picture should be paused.
• To restart playback, press
3 or 8.
7 To skip back/forward a chapter
or track, press
4·1 or
¡·¢.
• On the remote, use the
4 and ¢
buttons.
8 To scan backwards/forwards,
press and hold
4·1 or
¡·¢.
• On the remote, use the
1 and ¡
buttons.
• Release the button to resume normal
playback.
• If you scan for more than about 5
seconds, scanning continues even after
you release the button. In this case,
press
3 to resume normal playback.
9 To stop playback, press
7.
• If you start the disc playing again (
3),
playback starts from the point last
stopped (see Resuming play below).
• To switch the player off, press and hold
OFF (
7) for about two seconds.
Resuming play
When you stop playback, the player
remembers where on the disc you got to. As
long as you leave the disc in the player,
even if you switch the player off, the next
time you press
3, playback resumes from
that point.
To start playback from the beginning of the
disc again, press
7 while the disc is
stopped.
• For resume to work with CDs and DVD-
RW discs, do not switch the player off
using the front panel
OFF (
7) button.
If you have a CD loaded and want to
switch off, use the button on the
remote to put the player into standby.
• Resume may not work reliably with
some discs.
• When a DVD disc is loaded, pressing
4 or ¢ resumes playback from
the start of the title that was playing
when the disc was stopped last time.
• See also Bookmarking place on a disc
on page 35.