13 other settings, The input assign menu, Other settings – Pioneer VSX-515-S/-K User Manual
Page 75: Other settings 13, Chapter 13
Other Settings
13
75
En
English
Français
Deutsch
Nederlands
Italiano
Español
Chapter 13:
Other Settings
The Input Assign menu
You only need to make settings in the Input
Assign menu if you didn’t hook up your digital
equipment according to the default settings for
the digital inputs, or if you have connected
equipment using component video cables.
1
Select ‘IN ASSIG.’ from the System Setup
menu.
See
Making receiver settings from the System
Setup menu
on page 46 for more on this.
2
Use
/
(cursor left/right) to select the
setting you want to adjust then press
ENTER
.
•
DIG. IN
– See
Assigning the digital inputs
below.
•
COMP. IN
(
VSX-815/915 model only)
– See
Assigning the component video inputs
below.
Assigning the digital inputs
• Default settings:
COAX 1
(coaxial) –
DVD
COAX 2
(coaxial) –
CD
OPT 1
(optical) –
TV
VSX-815/915 model only –
OPT 2
(optical) –
DVR
You only need to do this if you didn’t hook up
your digital equipment according to the default
settings for the digital inputs (see above). This
setting tells the receiver what digital
equipment is hooked up to which terminal so
the buttons on the remote correspond to what
you have hooked up.
1
Select ‘DIG. IN’ from the ‘IN ASSIG.’ menu.
2
Select the number of the digital input to
which you’ve connected your digital
component.
Use the
/
(cursor left/right)
buttons to do
this.
• The numbers correspond with the
numbers beside the inputs on the back of
the receiver.
3
Select the component that corresponds
with the one you connected to that input.
Use the
/
(cursor up/down)
buttons to
select
DVD
,
TV
,
CD
,
CDR
,
DVR
or
OFF
.
• If you assign a digital input to a certain
function (for example,
DVD
) then any
digital inputs previously assigned to that
function will automatically be switched off.
4
When you're finished, press RETURN.
Assigning the component video inputs
VSX-815/915 model only
• Default settings:
COMP 1
–
DVD
COMP 2
–
TV
COMP 3
–
DVR
When you select an input source (
DVD/LD
,
TV/SAT
, etc.), the receiver outputs the
component video signal assigned to that
source. If you didn’t make component video
connections according to the defaults above,
you must assign the numbered input to the
component you’ve connected (or else you may
see the video signal of a different component).
For more on this, see
Using the component
video jacks
on page 20.
1
Select COMP. IN from the IN ASSIG. menu.
11_other_settings.fm 75 ページ ２００５年３月３日 木曜日 午後２時５１分