Pioneer DVR-650H-K - Manual (Page 47)

Recording
47
En
05
After setting up for Auto Start Recording, this
recorder starts recording when it detects a
signal from the other component. When the
signal ceases, the recorder stops recording.
If you want to use this recorder with the
timer features of your satellite tuner, see
Additional information for cable/satellite/STB
(set-top box) users
below.
Important
• It takes a little while for this recorder to
switch on and start recording after
detecting a signal. Please bear this in
mind when setting the timer.
• If Auto Start Recording is set, it will not
start if another timer recording is in
progress.
• Timer recordings take precedence over
Auto Start Recording. Auto Start
Recording will stop if a timer recording is
due to start. After the timer recording
has finished, Auto Start Recording will
resume.
1 Set the timer for the satellite receiver
(or other component), then switch it into
standby (if necessary).
Check the manual that came with the
receiver if you’re not sure how to do this.
2 Check that the ‘Audio In’ settings for
‘External Audio’ and ‘Dual Mono
Recording’ are as you want them.
See Audio In on page 105 for more on these
settings.
3 Set up the recorder.
• Use REC MODE to set the recording
quality. See Setting the picture quality/
recording time on page 36 for detailed
information.
4 Select ‘Timer Recording’, then
‘Auto Start Recording’ from the Home
Menu.
5 Select ‘Yes’ to switch Auto
Start Recording on, or ‘No’ to switch off.
If you choose ‘Yes’ the recorder
automatically goes into standby.
The AUTO indicator in the front panel
display lights.
The recorder will automatically switch on
and start recording when the other
component comes on. Recording stops
when the external component switches off.
• To cancel Auto Start Recording, press
STANDBY/ON while the recorder is in
standby. The AUTO indicator goes off.
• To cancel Auto Start Recording once
recording has already started, press
ì REC for three seconds (this cancels
Auto Start Recording, but recording
continues), then
STOP REC to stop
recording.
• You can also stop recording by pressing
STOP REC then selecting Yes to
confirm.
Tip
• Alternatively, with no OSD displayed,
press and hold the front panel
STOP REC button for more than three
seconds to switch Auto Start Recording
on directly. After switching on, switch
the recorder into standby.
Additional information for cable/
satellite/STB (set-top box) users
The following instructions show how to use
the timer features of your STB with this
recorder.
Setting up
1 Connect the STB’s audio/video
outputs to a set of audio/video inputs on
this recorder.
2 Switch on both the STB and this
recorder and switch the recorder’s input
function to the STB (L1, L2 or L3).
To check that everything is connected
properly, switch on your TV and select this
recorder as the video input. You should see
whatever the STB is tuned to.
HOME MENU
ENTER
DVR650HK_KC_EN.book 47 ページ ２００７年２月２１日 水曜日 午後４時３１分