Pioneer DV-667A-S - Manual (Page 14)

Connecting up 02
14
En
Easy connections
The setup described here is a basic setup that allows you to play discs using just the cables
supplied with the player. In this setup, stereo audio is played through the speakers in your TV.
• This player is equipped with copy protec-
tion technology. Do not connect this
player to your TV via a VCR using AV
cables, as the picture from this player will
not appear properly on your TV. (This
player may also not be compatible with
some combination TV/VCRs for the same
reason; refer to the manufacturer for
more information.)
• When connecting to your TV as shown
above, do not set the Component Out
setting ( page 56 ) to Progressive .
1 Connect the VIDEO OUT and AUDIO
OUT (2ch) jacks to a set of A/V inputs on
your TV.
Use the supplied audio/video cable,
connecting the red and white plugs to the
audio outputs and the yellow plug to the video
output. Make sure you match up the left and
right audio outputs with their corresponding
inputs for correct stereo sound.
See below if you want to use an S-video,
component or a D video connection.
• If you need another pair of stereo outputs
(and don’t need to use the multichannel
analog outputs), you can use the
AUDIO
OUT (5.1ch) FRONT L / R jacks
( page 17 ).
2 Connect the supplied AC power cable
to the AC IN inlet, then plug into a power
outlet.
S
L
R
L
R
P R
P B Y
COAXIAL
OPTICAL FRONT SURROND
SUB
WOOFER
CENTER
CONTROL
IN OUT
DIGITAL
AUDIO OUT
COMPONENT VIDEO OUT
AUDIO OUT(2CH)
AUDIO OUT
(5.1CH)
VIDEO OUT
TV
A/V IN
To power outlet
DV563.book 14 ページ ２００３年４月２５日 金曜日 午後８時１１分