Additional information 10 – Pioneer DV-667A-S User Manual
Page 83
Additional information
10
83
En
No picture/No color.
• Incorrect video connections: Check that connections are correct
and that plugs are inserted fully. Also check the video cable for
damage.
• TV/monitor or AV amplifier settings are incorrect: Check the
instruction manual of the connected equipment.
• The video output is set to progressive but your TV/monitor is not
compatible with progressive scan: See
page 56
for how to set to
interlace.
• When set to progressive video output, there is no video output from
the composite or S-video outputs.
Screen is stretched or
aspect does not change.
• The
TV Screen
setting in the Initial Settings menu is incorrect. See
page 72
for how to set it correctly for your TV/monitor.
• If your TV/monitor is connected using an S-video cable, try changing
the
S-Video Out
setting (
page 58
).
Picture disturbance
during playback or the
picture is dark.
• This player is compatible with Macro-Vision System copy guard.
Some discs include a copy prevention signal, and when this type of
disc is played back, stripes etc., may appear on some sections of the
picture depending on the TV. This is not a malfunction.
• Due to the player’s copy protection circuits, connection of this
device through a VCR or an AV selector may prevent recording or
cause picture problems. This is not a malfunction.
• The TV system may be set inappropriately. See Setting the TV
System on
page 81
.
No audio, or audio is
distorted.
• No audio is output during slow motion playback or when scanning
discs other than audio CDs
• Some DVD discs do not output digital audio: Switch your amplifier
to the player's analog outputs.
• Check that the disc is free from dust and dirt, and that it is not
damaged (
page 70
).
• Check that all interconnects are firmly inserted.
• Check that the plugs and terminals are free of dirt, oxide, etc. and
clean if necessary. Also check the cable for damage.
• Make sure the player's output is not connected to the amplifier's
phono (turntable) inputs.
• Check your amplifier/receiver’s settings (volume, input function,
speaker settings, etc.).
The analog audio is OK,
but there appears to be
no digital audio signal.
• Make sure that the
Digital Out
setting is set to
On
(
page 54
).
• Check that the Dolby Digital, DTS and MPEG out settings
(
pages 55
–
56
) are suitable for your amplifier/receiver—check the
instruction manual that came with your amplifier/receiver.
• SACDs and some DVD-Audio discs do not output digital audio.
Listen through the player’s analog audio outputs.
Problem
Remedy
DV563.book 83 ページ ２００３年４月２５日 金曜日 午後８時１１分