POSIFLEX Business Machines PP7700 Series - Manual (Page 21)

2 - 11
the power while the “Feed” button is pressed can prepare PP7700
for the signal detect operation. Now in the host Posiflex POS
system, please execute the “Connect” with the BT ID of the
PP7700 entered in the appropriate field and click for “Connect”.
Ignore any warning message that would popup later. Press the
“Feed” button on PP7700 again and PP7700 will flash its Error
LED to indicate the wireless connection condition. The faster the
LED flash (up to a little bit faster than 1 flash / sec) indicates a
better connection condition. If the signal detect signal flashes too
slow or even steady on or off, it may need to shorten the printer --
host distance or to check the environment again and you may
move the PP7700 around and adjust the antenna direction before
final decision on location setup. Please adjust the position of the
host system and Dongle antenna direction when necessary. It is
quite commonly experienced that several centimeter move or
turning the directions of either the host or the printer can make
significant influences. Please also take into consideration the
operation area of operating personnel as human body usually
influences wireless communication a lot.
After fixing the location setup you may turn off PP7700 and
reload the paper roll to prepare for normal operation. Terminate
the “Signal detect” function at the host and go for application
program at the host system.
4. Peripheral Connection
The peripheral controller is a RJ11 jack near the serial
connector. With use of Posiflex cash drawer cable 20863018001
(CCBLA-180-1) come with cash drawer, this port can control a
Posiflex cash drawer CR3100 or CR3200 or CR4000 or CR4100.
If a Posiflex special split cable 20867023800 (CCBLA-238) is
used instead, this port can control two cash drawers of above
models.