POSIFLEX Business Machines PP7700 Series - Manual (Page 41)

5 - 5
guide adaptor for use with the paper roll of 58 mm width, the
switch should be set to ON in PP7700.
Switch position 3 is usually set to OFF for ESC/POS
command application that prints at 512 dots / line. Only technical
users shall set this switch to ON and make the printer work in the
576 dots / line format.
D. SOFTWARE COMMANDS
The Aura thermal printer supports all commands applicable
to Epson printer TM-T88II. The only difference is the
smoothening command in enlarged text fonts. Please visit our
web site http://www.posiflex.com.tw, http://www.posiflextw.com
or http://www.posiflexusa.com for detail description of the
supported commands if required.
1.
Paper Out Alarm
When Paper End signal is detected, the printer keeps on
intensive beeping and stops receiving data till the signal is
neutralized.
When Paper Near End signal is detected, the
printer gives a beep every 3 seconds and stops receiving data.
2.
Enhancement Commands
Following commands are included in the printer firmware:
ESC ‘o’: Beep command
GS ‘o’ m: Beep definition (0 < m
16, default 3 seconds)
ESC ‘p’ m n
1
n
2
: Cash drawer kick or kitchen bell drive
command
GS ‘p’ m n: Beep when cash drawer remain open (0 < m <
256, n = ‘0’ or ‘1’)
Explanations as below:
ESC ‘o’: Beep command