POSIFLEX Business Machines PP7700 Series - Manual (Page 22)

2 - 12
When the printer is used as a kitchen printer and a kitchen
bell is prepared, please use this port for kitchen bell connection
instead.
5.
Power Connection
The power connector is a 3 pin jack next to the peripheral
connector. Either a Posiflex supplied power adaptor or a printer
power cable from a Posiflex POS system can be connected to this
connector to supply power for this printer. During insertion of the
power plug, be sure to hear the click to obtain a firm contact.
CAUTION: Before doing the insertion or extraction of the
power plug, be sure to pull the outer sleeve of the
plug backward to release the internal latch.
Failure to do this could damage the power plug.
Such damage is considered as an artificial
destruction and is not covered by the warranty.
6.
Power On
When all the above cable connections are made correctly,
you may connect your power adaptor to the wall outlet. Make
sure that the type of power cord and the voltage requirement of
the power adaptor meet the local power conditions. Now the
printer is ready for power on.
7.
Self Test
With the paper roll loaded in the printer press and hold
down the feed button while push the on / off switch on. The
printer will then perform a self test. A sample slip of self test
result is printed below.
The header of this slip is printed in text mode and the rest
part is in page mode. If FEED button is pressed at this moment, a