Panasonic AJ-D850A - Manual (Page 35)

– 35 –
Checking the edit points
1
Press the IN (or OUT) button to check the edit point.
The value of the entered edit point appears on the display.
2
Press the PREROLL button while holding down the IN (or OUT) button to check the
image at the edit point.
The tape is cued at the edit IN (or OUT) point, and the still picture mode at that point is
displayed.
• The EE mode is established if the TAPE/EE switch has been set to the “EE” position
when “STOP” has been selected for the setup menu No. 313 (AFTER CUE-UP).
3
Press and hold down the IN and OUT buttons together to check the edit duration.
The duration time appears on the display.
Calculating the duration
• When both edit points have been set, the duration between the two edit points.
• When only one edit point has been set, the duration between the set data and the current
tape address.
• When neither edit point has been set, the duration of the previously edited interval.
2 1, 3
ON
OFF
L
LEVEL CUE VIDEO
ASSEMBLE
DV
AUDIO ANALOG
VIDEO Y PB PR
AES/EBU
CMPST
INPUT SELECT
CH CONDITION
SCH CF
SHIFT ADJ START RESET
STAND BY
UB EXT EE
TC INT
TC MODE
TAPE
LOCAL REV FWD
PULL
OPEN
JOG
PUSH
EJECT
AUTO OFF
SHTL
SLOW
CONTROL
REMOTE
EDIT
REW
PLAY
SERVO
STOP
PLAYER
REC
REC INHIBIT
FF
RECORDER
TC/CTL
TC SET
INSERT-
VIDEO CH1 CH2 CUE TC
AUTO EDIT PREROLL
PREVIEW
REVIEW
REC
PB
PULL FOR VARIABLE
PULL
OPEN
HEADPHONES
CH1 CH2
R
MONITOR SELECT
W
TRIM
IN SET
– +
OUT
A
OUT
A
IN
METER
FULL/FINE
POWER
USER SET SDI
SDI SDTI(V&A)