Panasonic AJ-D850A - Manual (Page 71)

– 71 –
USER menu
<VIDEO> (continued)
Item Setting
No.
Superimposed
No.
Superimposed Description
display display
614 VOUT 0000 THRU
SETUP 0001 ADD
616 CMPNT 0000 THRU
SETUP 0001 CUT
617 INTER- 0000 OFF
POLATE 0001 AUTO
650 SER IN 0000 MANU
MODE 0001 AUTO
652 SER OUT1 0000 SDI
SEL 0001 SDTI
0002 AUTO
The underline on the setting item denotes the initial setting.
This selects the composite output signal.
0: The signal is output without setup.
1: The signal is output with 7.5% setup.
<Note>
When setting this menu item, bear the setup menu No. 616
(CMPNT SETUP) setting in mind.
When composite, component and serial (digital) signals are to
be output:
0: They are output in their original form.
1: They are output without the 7.5% setup signal.
Although vertical interpolation is performed automatically
during slow-motion playback and the vertical motion of the
playback picture is reduced, this menu item enables the
interpolation operation to be forcibly turned off.
0: The interpolation operation is forcibly turned off.
1: The interpolation operation is automatically turned on
during slow-motion playback.
This selects the serial input mode.
0: The setting reflects what is selected by the INPUT SELECT
switch on the front panel.
1: SDTI or SDI signals are automatically selected in accordance
with the format of the serial input signals.
The INPUT SELECT display on the front panel is switched
automatically to match the input signals.
<Note>
This menu item can be set only when the AJ-YAC850P SDTI/
SDI interface board has been installed.
This selects the signals which are to be output to serial output 1.
0: SDI signals are output.
1: SDTI signals are output.
2: SDTI signals are output during DVCPRO playback or which
in the EE mode; SDI signals are output during DV or
DVCAM playback.
<Note>
This menu item can be set only when the AJ-YAC850P SDTI/
SDI interface board has been installed.