Panasonic AJ-D850A - Manual (Page 68)

Setup menus
– 68 –
USER menu
<TIME CODE> (continued)
Item Setting
No.
Superimposed
No.
Superimposed Description
display display
501 VITC 0000 10L
POS-2 0001 11L
0002 12L
0003 13L
0004 14L
0005 15L
0006 16L
0007 17L
0008 18L
0009 19L
0010 20L
502 VITC 0000 BLANK
BLANK 0001 THRU
503 TCG 0000 TC&UB
REGEN 0001 TC
0002 UB
504 REGEN 0000 AS&IN
MODE 0001 ASSEM
0002 INSRT
0003 SW
505 EXT TC 0000 LTC
SEL 0001 VITC
506 BINARY 0000 000
GP 0001 001
0002 010
0003 011
0004 100
0005 101
0006 110
0007 111
507 PHASE 0000 OFF
CORR 0001 ON
508 TCG CF 0000 OFF
FLAG 0001 ON
509 DF MODE 0000 DF
0001 NDF
The underline on the setting item denotes the initial setting.
This sets the position where the VITC signal is to be inserted.
(The same line as for VITC POS-1 in 500 cannot be selected.)
This selects whether to output the VITC data to the positions
selected by VITC POS-1 in 500 and VITC POS-2 in 501.
0: Data is not output.
1: Data is output.
This selects the signal to be regenerated when the time code
generator (TCG) in the REGEN mode.
0: Both the time code and user bit are regenerated.
1: Only the time code is regenerated.
2: Only the user bit is regenerated.
This selects whether the time code is to be regenerated during
automatic editing using the unit’s control panel.
0: Time code is regenerated with assemble or insert editing.
1: Time code is regenerated with assemble editing.
2: Time code is regenerated with insert editing.
3: Setting complies with REGEN/PRESET switch setting.
This selects the time code to be used when an external time
code is to be used.
0: The LTC of the TIME CODE IN connector is used.
1: The video signal VITC is used.
This sets the usage status of the user bit of the time code
generated by the TCG.
0: NOT SPECIFIED (character set not specified)
1: ISO CHARACTER (8 bits character set based on ISO646,
ISO2022)
2: UNASSIGNED 1 (undefined)
3: UNASSIGNED 2 (undefined)
4: UNASSIGNED 3 (undefined)
5: PAGE/LINE
6: UNASSIGNED 4 (undefined)
7: UNASSIGNED 5 (undefined)
This selects whether to control the phase correction of the
LTC generated by the TCG.
0: Phase correction control is not performed.
1: Phase correction control is performed.
This selects whether the CF flag of the TCG is to ON.
0: CF flag is OFF.
1: CF flag is ON.
This selects the DF/NDF mode for CTL and TCG.
0: Drop frame mode.
1: Non-drop frame mode.
No. 509 is valid when the CONTROL is LOCAL or LOCAL
ENA of item 004 to “ENA”.