Panasonic AJ-D850A - Manual (Page 70)

Setup menus
– 70 –
USER menu
<VIDEO>
Item Setting
No.
Superimposed
No.
Superimposed Description
display display
600 P B /P R 0000 M II
IN LV 0001 B-CAM
601 INT BB 0000 OFF
SIG 0001 BB
602 INPUT C 0000 B/W
KILL 0001 AUTO
603 OUT 0000 N-VF
VSYNC 0001 VF
604 V-MUTE 0000 N-MUTE
SEL 0001 LOW RF
605 CC (F1) 0000 BLANK
BLANK 0001 THRU
606 CC (F2) 0000 BLANK
BLANK 0001 THRU
608 FREEZE 0000 FIELD
SEL 0001 FRAME
610 OUT C 0000 B/W
KILL 0001 COLOR
611 EDH 0000 OFF
0001 ON
613 VIN SETUP 0000 THRU
0001 CUT
The underline on the setting item denotes the initial setting.
This selects the component input signal level.
0: M
II level.
1: ß cam level.
This selects whether to generate the internal black burst
signal.
0: Signal is not generated.
1: Signal is generated.
This selects color killer processing for the video input signals.
0: The signals are forcibly processed as B/W signals.
1: The signals are automatically processed.
This selects whether to float the vertical sync position of the
video output in order to align the video output phase with
the input in the EE/record/edit modes.
0: Signals are not floated.
1: Signals are floated.
This selects whether the video output signals are to be muted
when the blank portion of the tape is detected during play-
back.
0: No muting. (Freeze)
1: Muting. (Set to gray.)
This selects ON or OFF for the closed capture signal in the
first field.
0: Forced blanking performed.
1: Blanking not performed.
This selects ON or OFF for the closed capture signal in the
second field.
0: Forced blanking performed.
1: Blanking not performed.
This selects the freeze mode for still pictures.
0: Field freeze.
1: Frame freeze.
<Note>
When frame freeze has been selected, the frame slow status
is established with the slow setting.
This selects chroma color killer processing for the video output
signals.
0: The signals are forcibly processed as B/W signals.
1: The signals are automatically processed.
This selects whether to superimpose EDH onto the serial
output signals.
0: EDH is not superimposed.
1: EDH is superimposed.
<Note>
This item is valid when the optional serial interface board has
been installed.
This selects whether the composite signal is to be recorded
with setup or without setup.
0: When recording signals with no setup.
1: When recording signals with 7.5% setup.
<Note>
When recording composite signals, be sure to double-check
whether the signals are to be recorded with or without setup.