Pride Mobility QUANTUM 1121 - Manual (Page 19)

Quantum 1121 www.quantumrehab.com 19
I V . A S S E M B L Y
INITIAL ASSEMBLY
Your power chair may require some assembly either before initial use or after transportation. It may also require disassem-
bly to make some comfort adjustments.
NOTE: Any nylon insert lock nut removed during the disassembly or adjustment of the power chair must be
replaced with a new nut. Nylon insert lock nuts should not be reused as it may cause damage to the nylon
insert, resulting in a less secure fit. Replacement nylon insert lock nuts are available at local hardware stores
or through your Quantum Rehab Specialist.
Seat Installation
The Universal Mounting System (UMS) consists of universal parts that may be used on the Specialty Seat or any high-
back seat, regardless of seat width or seat depth. The two main components are aluminum extrusions that can be mounted
to the seat base. These extrusions attach to a pair of trapeze bars that are mounted to four steel towers. If your power chair
is equipped with a Specialty Seat, Synergy Seat, or Synergy TRU-Balance, refer to the information provided in separate
manuals. If your power chair is equipped with a high-back seat, a reclining seat, or a power elevating seat, refer to the
following information.
WARNING! Do not pick up the seat frame by the armrests. They are free to pivot, and you may lose control
of the seat if they do so, resulting in personal injury or damage to the chair.
Figure 11. Universal Mounting System Figure 10. Universal Mounting System (Power Seat)