Pride Mobility QUANTUM 1121 User Manual
Page 20
20
www.quantumrehab.com
Quantum 1121
To install the seat:
1. Set the seat towers to the desired height. To change the seat height, see V. “Comfort Adjustments.”
2. Tilt the seat back, and slide the rear extrusion onto the rear trapeze bar.
3. Lower the front extrusion onto the front trapeze bar until the seat locks into place..
4. Flip the seat latch safety down.
WARNING! Make sure the seat latch safety is flipped down before using your power chair.
5. Install the controller into one of the armrests. See V. “Comfort Adjustments.”
6. Plug the controller cable(s) into the connector on the electronics tray.
7. Route the cable to ensure that the cable cannot be pinched in the seat hinge.
8. Secure the controller cable to the armrest receiver with one or more wire ties.
I V . A S S E M B L Y