Pride Mobility QUANTUM 1121 - Manual (Page 23)

Quantum 1121 www.quantumrehab.com 23
V . C O M F O R T A D J U S T M E N T S
Figure 16. Controller Installation
SETSCREW
Figure 17. Foot Platform Height Adjustment
Figure 18. Foot Platform Angle Adjustment
FOOT PLATFORM
BRACKET NUTS AND
BOLTS
BALL
DETENT PIN
SETSCREW
Controller Position
You can position the controller for either left-hand or right-hand use.
WARNING! Do not place the controller cable so that it
can be pinched in the seat frame or the power base frame.
To change the controller position:
1. Turn off the power to the controller.
2. Unplug the controller connector and the charger inhibit connector
(if equipped) from the electronics tray. See figure 7.
3. Cut the wire tie(s) securing the controller cable to the armrest.
4. Flip up the armrest and loosen the setscrew. See figure 16.
5. Slide the controller out of the armrest.
6. Loosen the setscrew in the other armrest.
7. Place the controller in the other armrest.
8. Tighten the setscrew and secure the controller.
9. Use a wire tie to secure the controller cable to the armrest.
10. Reconnect the controller to the electronics tray.
Armrest Height Adjustment
To change the armrest height:
1. Loosen the two setscrews located on the armrest receiver.
2. Raise or lower the armrest to the desired height. See figure 15.
3. Tighten the setscrews to secure the armrest.
Armrest Angle Adjustment
To change the armrest angle:
1. Lift the armrest straight up so that it is perpendicular to the floor.
2. Loosen the jam nuts. See figure 15.
3. Loosen the armrest angle adjustment screw.
4. Turn the adjustment screw clockwise to raise the front of the arm-
rest, or turn the adjustment screw counterclockwise to lower the
front of the armrest. See figure 15.
5. Tighten the jam nuts to lock the adjustment screw into place.
Foot Platform Height Adjustment
The foot platform height is easily adjusted to one of six different heights in
1-in. increments.
To raise or lower the foot platform:
1. Remove the nuts and bolts from the foot platform bracket. See figure 17.
2. Raise or lower the foot platform to the desired height.
3. Reinstall the nuts and bolts into the foot platform bracket and tighten.
Foot Platform Depth Adjustment
To adjust the foot platform depth:
1. Remove the nuts and bolts from the foot platform bracket. See figure 17.
2. Move the foot platform in or out to the desired depth.
3. Reinstall the nuts and bolts into the foot platform bracket and tighten.