Paradyne 3161-B3 - Manual (Page 271)

H. Asynchronous Terminal Operation
3160-A2-GB21-90 February 2001 H-15
Configuration Worksheets for the Asynchronous Terminal Interface
This section contains one set of blank worksheets to be used when configuring
your DSU/CSU using the async terminal interface. In the tables, default settings
for Default Factory 1 are indicated by bold type. It is recommended that you copy
these blank worksheets before using them.
Network Interface
Options
Front Panel Equivalent Value (Default in Bold)
Line Framing Format NET Framing D4, ESF
Line Coding Format NET Coding AMI, B8ZS
Line Build Out (LBO) LBO 0.0, –7.5, –15, –22.5
Management Link Mgmt Link Enable, Disable
Bit Stuffing BitStuff 62411, Part68, Disable
Network Initiated LLB NET LLB Enable, Disable
Network Initiated PLB NET PLB Enable, Disable
ANSI Performance Report
Messages ANSI PRM Enable, Disable
Circuit Identifier Circuit Ident Text Field, Clear
DTE Interface Options Front Panel Equivalent Value (Default in Bold)
Interface Status DTE Port Enable, Disable
Line Framing Format DTE Framing D4, ESF
Line Coding Format DTE Coding AMI, B8ZS
Line Equalization Equal 0–133, 133–266, 266–399,
399–533, 533–655
DTE LB on External
Contact Extrn DLB Enable, Disable
Send All Ones on DTE
Failure Send Ones Enable, Disable