Panasonic PT-D9610U - Manual (Page 38)

38
2. 1) 480p single link (4:2:0p): 59.94 Hz progressive scan with 720 by 483 active lines at
360 Mbps, complying with the SMPTE294M Standard
2) 480i (4:2:2): 59.94 Hz interlace scan with 525 lines at 270 Mbps, complying with
the SMPTE294M Standard
3) 576i (4:2:2): 50 Hz interlace scan with 625 lines at 270 Mbps, complying with the
SMPTE294M Standard
SD signal SD signal output
(Active through)
Serial digital input module(sold separately)
MAIN IN
Professional-type
digital VCR
ET-MD95SD2 (for 480p/480i/576i)
480p Module
ET-MD95SD2
SERIAL
MAIN OUT SUB IN SUB OUT
• Use an input module which correctly matches the input signal type.
• Input modules that accommodate the 4 video signal formats described above can be switched from one to
another with the SYSTEM SELECTOR button that cycles through those signal formats. The selected input
signal is indicated by an OSD message that automatically goes off.
• The SYSTEM SELECTOR should normally be set in the AUTO position.
• The automatic scan format identification logic may malfunction if signal connections other than those
described above are employed or an unstable video signal is applied. In such an event, use the SYSTEM
SELECTOR button to select the scan format that matches the video signal format applied.
• To ensure correct video signal transmission, use 3C2W or better than 3C2W cables for video interconnections
(e.g., 3C2W, 3CFB, 4CFB, 5C2W, 5CFTX, 7CFB, etc.).
Connecting the signal source to the input module for serial digital signals
•Leave the SUB IN/OUT terminals
open.