Panasonic PT-D9610U - Manual (Page 70)

70
Setting remote control unit ID numbers
When an ID number has been assigned for a projector, you then need to assign the same ID number as the
projectors to be controlled to the remote control unit which is to be used to operate these projectors, otherwise the
remote control unit cannot be used.
Because the factory pre-setting of the projector ID number is ALL, using only one projector requires the use of the
ID ALL button on the remote control unit for this setting.
Setting method
Within 5 seconds of pressing the ID SELECT button, use the NEXT button to set the tens digit of the ID number
which has been assigned to the projector, and then use the numeric buttons (0 to 9) to set the units digit.
However, if the ID ALL button is pressed, the remote control unit will operate the projector regardless of which ID
number has been assigned to the projector.
• If the NEXT button or a numeric button is not pressed within 5 seconds of pressing the ID SELECT button, the ID
number will return to the setting prior to when the ID SELECT button was pressed.
• Setting an ID number for the remote control unit can be carried out without needing the projector, so be careful
not to press the ID SELECT button inadvertently.
• Once an ID number has been assigned to the remote control unit, that ID number will be stored in the remote
control unit until it is again changed. However, if the remote control unit is left with flat batteries inside it, the ID
number setting will be cleared. When the batteries are replaced, re-assign the same ID number to the remote
control unit.
If you do not know the ID number assigned to the projector
If you do not know what ID number has been assigned to the projector, turn on the
projector so that it is operating, and then press the ID SELECT button. The ID number
will then be displayed on the screen as shown at right.
The ID number for the projector can be set to ALL or to a number from 1 to 64.