Planet Technology WGSW-48040 - Manual (Page 365)

User’s Manual of WGSW-24020/WGSW-48040
-36
no dot1x auth-not-req
This command has no arguments or keywords.
Default Configuration
User should be authorized to access the VLAN.
Command Mode
Interface configuration (VLAN) mode
User Guidelines
To define a VLAN for authorized and unauthorized users use the dot1x auth-not-req interface VLAN command.
Examples
The following example enables unauthorized users access to the VLAN.
console config-if(Config-VLAN)# dot1x auth-not-req
5.29.16 dot1x multiple-hosts
The dot1x multiple-hosts interface configuration command allows multiple hosts (clients) on an 802.1X-authorized port, that
has the dot1x port-control interface configuration command set to auto. Use the no form of this command to return to the
default setting.
dot1x multiple-hosts
no dot1x multiple-hosts
This command has no arguments or keywords.
Default Configuration
Multiple hosts are disabled. If a port would join a port-channel, the state would be multiple hosts as long as the port is member in
the port-channel.
Command Mode
Interface configuration (Ethernet) mode
User Guidelines
This command enables the attachment of multiple clients to a single 802.1X-enabled port. In this mode, only one of the attached
hosts must be successfully authorized for all hosts to be granted network access. If the port becomes unauthorized, all attached
clients are denied access to the network.
If a port would join a port-channel, the state would be multiple host as long as the port is member in the port-channel.
Examples
The following command allows multiple hosts (clients) on an 802.1X-authorized port.
console config-if(Config-VLAN)#dot1x multiple-hosts