Planet Technology WGSW-48040 - Manual (Page 21)

User’s Manual of WGSW-24020/WGSW-48040
-21-
2.2.2 Rack Mounting
To install the Switch in a 19-inch standard rack, please follows the instructions described below.
Step1 : Place the Switch on a hard flat surface, with the front panel positioned towards the front side.
Step2 : Attach the rack-mount bracket to each side of the Switch with supplied screws attached to the package. Figure 2-5
shows how to attach brackets to one side of the Switch.
Figure 2-5 Attach brackets to the Switch.
Caution:
You must use the screws supplied with the mounting brackets. Damage caused to the parts by using incorrect screws
would invalidate the warranty.
Step3 : Secure the brackets tightly.
Step4 : Follow the same steps to attach the second bracket to the opposite side.
Step5 : After the brackets are attached to the Switch, use suitable screws to securely attach the brackets to the rack, as shown in
Figure 2-6.
Figure 2-6 Mounting the Switch in a Rack