Planet Technology WGSW-48040 - Manual (Page 43)

User’s Manual of WGSW-24020/WGSW-48040
-43-
4.4.2 Port setting
In this port setting screen (refer to figure 4-15), the parameters managing ports that are part of a VLAN will be provided, and you
can set the default VLAN ID (PVID). All untagged packets arriving to the device are tagged by the ports PVID.
Figure 4-15 VLAN Port Setting screen
The page contains the following fields:
Port Displays the port number included in the VLAN.
Mode Indicates the port mode. Possible values are:
• General - The port belongs to VLANs, and each VLAN is user-defined as tagged or
untagged (full 802.1Q mode).
• Access - The port belongs to a single untagged VLAN. When a port is in Access
mode, the packet types which are accepted on the port (packet type) cannot be
designated. It is also not possible to enable/ disable ingress filtering on an access
port.
• Trunk - The port belongs to VLANs in which all ports are tagged (except for an
optional single native VLAN).
Acceptable Frame Type Packet type accepted on the port. Possible values are:
• Admit Tag Only - indicates that only tagged packets are accepted on the port.
• Admit All - indicates that both tagged and untagged packets are accepted on the
port.
PVID Assigns a VLAN ID to untagged packets. The possible values are 2 to 4094. VLAN 4095 is
defined as per standard and industry practice as the discard VLAN. Packets classified to
the Discard VLAN are dropped.
Ingress Filtering Enables or disables Ingress filtering on the port. Ingress filtering discards packets which
do not include an ingress port.
LAG Indicates the LAG to which the VLAN is defined.