Pioneer Super Tuner III D DVH-P5850MP - Manual (Page 61)

Black plate (61,1)
<CRB2123-A/U>61
Introduction of DSP
adjustments
Important
Following functions are effective only when you
connected a Pioneer multi-channel processor
(DEQ-P7650) to this unit.
By carrying out the following settings/adjust-
ments in the order shown, you can create a fi-
nely-tuned sound field effortlessly.
1 Setting the speaker setting
2 Using the position selector
3 Auto TA and EQ (auto-time alignment and auto-
equalizing)
4 Adjusting the time alignment
5 Adjusting the speaker output levels using a
test tone
6 Selecting a cross-over frequency
7 Adjusting the speaker output levels
8 Adjusting 3-band parametric equalizer
Operating the DSP menu
1
2 2 2
1 DSP display
Shows the DSP status.
2 Subwoofer indicator
Shows when the subwoofer output is turned
on.
% Press A to display the DSP function
names.
Press A repeatedly to switch between the fol-
lowing DSP functions:
POSI (position selector)FAD (balance ad-
justment)SLA (source level adjustment)
DRC (dynamic range control)DIRCT (di-
rect)Lo/Ro (down mix)
# When selecting the FM tuner as the source,
you cannot switch to SLA, DRC.
# When playing other than the DVD disc, you
cannot switch to DRC.
# To return to the display of each source, press
BAND.
Note
If you do not operate the DSP function within
about 30 seconds, the display is automatically re-
turned to the source display.
Digital Signal Processor
En
61
Section
12
Digital
Signal
Proce
ssor