Pioneer Super Tuner III D DVH-P5850MP - Manual (Page 88)

Black plate (88,1)
<CRB2123-A/U>88
Symptom Cause Action (See)
Repeat play and track/time
search are not possible.
The Video CD playing features PBC. This operation is not possible with Video CDs
featuring PBC.
DSP
Symptom Cause Action
Speakers are not available to be
adjusted.
Their size settings is at OFF. Make the correct size settings. (Page 66)
Time alignment is not available. Listening position is not set cor-
rectly.
Set listening position correctly. (Page 63)
Speaker size settings is at OFF. Make the correct size settings. (Page 66)
The subwoofer is not available to
switch its phase.
The subwoofer is set to OFF. Set the subwoofer to ON. (Page 66)
Bass content is not heard. The subwoofer is set to OFF and yet
other speakers are set to OFF or
SML in size.
Make the correct settings. (If no subwoofer is
installed, the front or rear speaker needs to
be set to LRG.) (Page 66)
Ocassionally no sounds are out-
put when Dolby Pro Logic II is
turned on.
The center speaker setting is at SML
or LRG whereas no center speaker
is installed.
Change the center speaker size setting to
OFF. (If the audio source is mono and Dolby
Pro Logic II is turned on, sound is heard over
the center speaker only.) (Page 66)
Occasionally no sounds are
heard over speakers other than
the center one.
Dolby Pro Logic II is turned on. Turn Dolby Pro Logic II off. (If the audio
source is mono and Dolby Pro Logic II is
turned on, sound is heard over the center
speaker only.) (Page 65)
Turning dynamic range control
on has no effects.
The currently reproduced sound is
not Dolby Digital coded.
The feature is only effective on Dolby Digital
sounds. (Page 64)
No sounds are heard. Optical cables are incorrectly con-
nected.
Connect the cables correctly.
Error messages
When you contact your dealer or your nearest Pioneer Service Center, be sure to record the error
message.
Error messages
Message Cause Action (See)
ERROR-02 Dirty disc Clean disc.
Scratched disc Replace disc.
TEMP The temperature of this unit is out-
side the normal operating range
Wait until the units temperature returns to
within normal operating limits.
Additional Information
En
88
Appendix